Convert Your Dresser Mirror To An Elegant Flat Screen Frame

Warm Bedroom Decorating Ideas by Huelsta - DigsDigsNot that this is bedroom furniture that we love, since our tastes have changed through the years, but sometimes it can be hard to would like to get rid of quality furnishings until they have got served their very last objective. The future may hold the dark stain for the bedroom items, so they may be around long enough to come back to having a regular mirror.

Well, this particular poor dresser mirror had not been utilized in our previous home for four years because there was not an appropriate wall structure to place both the dresser and reflect together. And honestly I in no way missed it since all of our cabinets were in the master bath, plus larger bathroom mirrors did the task. However, our new home’s flooring plan allowed us to restore the mirror (or at least the particular frame). Having a large “black hole” around the wall of our master bedroom as not really appealing at all, but displaying this in an unique way was.

First the frame was place on the non-scratching surface with the back part up, and all hanging fixtures, staples and screws were removed to consider off the press board backing. After carefully lifting the mirror out there, it was stored upright behind the particular master bedroom armoire. At first the idea was to just get rid of the glass, however the mirror was cut to the form of the frame, with many curves plus angles, and was beveled. If there would ever be a cause to use the mirror again, it will be very expensive to replace.

Since the TV plus mount had already been installed, it had been lifted off the mount in order to not remove and re-install the equipment in case it would compromise the mount’s sturdy installation. It then necessary some careful measuring and calculating for the location of the hole we might need on the press board back again for where the TV would suspend reasonably centered within it’s edge.

After learning through experience, it is best to make the opening as large as you can without compromising the sturdiness from the backing, making sure none of the starting will show from behind the television screen, and high enough to ensure that when the TV must be lifted upward and over the mounting bar, you might have room to get it attached safely as well as not pinching any wires or wiring.

The chosen material (use upholstery quality) was organized face down, and two levels of batting (chose your width to you liking) were placed on best. Then came the press panel, centered to allow a similar amount of playing baseball and fabric all around it in order to fold it over all the sides for attaching. Cut an x-shaped hole in the center opening (where the mount will be located) plus fold back.

First duct recording was used to adhere the playing baseball and fabric so that it would be consistently “fluffy” to emphasize the padding. Be sure to extend the fabric plus tape far enough in plus creased/folded neatly around all sides so that it will look attractive if the body is seen from the side. Then little screws were replaced in the exact same location in the press board, as well as the same for the mounting hardware. The wall was marked for in which the mounting hardware would hang on every side. Then everything was set up. It’s quite a conversation piece plus and source of pride to have completed it ourselves.

Leave a Reply

Your email address will not be published. Required fields are marked *